by RichardP » Sun May 01, 2011 12:53 pm
How about these? I found that there are 4 distinctly different types of C-tractor so I choose 2 of them (covering Nos 1-11). The only actual dimenisons I have are LAO and beam, everything else is estimated from online images. So no guarantee of any accuracy....
The only other addition I considered was the 3 winches they all have but I've run out of enthusiasm for this particular project - I find working without scale drawings is particularly taxing. You'd have to supply railings, ladders etc from PE and brass rod.
Scale is 1/350; I'm not going to try 1/700. Photos are of the castings I am able to make now ( I don't think I have the ability to cast these successfully in 1/700). Each set consists of three seperate parts: hull, superstructure and wheelhouse.
C-Tractor 6-11
C-Tractor 1-5
How about these? I found that there are 4 distinctly different types of C-tractor so I choose 2 of them (covering Nos 1-11). The only actual dimenisons I have are LAO and beam, everything else is estimated from online images. So no guarantee of any accuracy....
The only other addition I considered was the 3 winches they all have but I've run out of enthusiasm for this particular project - I find working without scale drawings is particularly taxing. You'd have to supply railings, ladders etc from PE and brass rod.
Scale is 1/350; I'm not going to try 1/700. Photos are of the castings I am able to make now ( I don't think I have the ability to cast these successfully in 1/700). Each set consists of three seperate parts: hull, superstructure and wheelhouse.
[attachment=0]_MG_3329.JPG[/attachment]
C-Tractor 6-11
[attachment=6]_MG_3323.JPG[/attachment][attachment=5]_MG_3324.JPG[/attachment][attachment=4]_MG_3325.JPG[/attachment]
C-Tractor 1-5
[attachment=3]_MG_3326.JPG[/attachment][attachment=2]_MG_3327.JPG[/attachment][attachment=1]_MG_3328.JPG[/attachment]