rotateing radars

Post a reply

Confirmation code
Enter the code exactly as it appears. All letters are case insensitive.

BBCode is ON
[img] is ON
[url] is ON
Smilies are OFF

Topic review
   

Expand view Topic review: rotateing radars

Re: rotateing radars

by Harquebus » Mon Jun 01, 2015 6:56 pm

Since we don't know your precise application or what your vessels have in terms of radar, in general you will need a hollow mast or a tube to run a small wire drive shaft through. Locate the gear motor under the superstructure and connect it to the drive shaft and to the radar.

This gear motor is just for an example of what you could use: http://www.robotshop.com/en/solarbotics ... motor.html: GM17 228:1 Gear Motor w/Offset Shaft. Product Code : RB-Sbo-41 by Solarbotics

It specifies 32 RPM at 6V which is about radar speed. It is not fast but slow and steady. Lower voltage would slow it down even more and the reverse is also true.

EDIT: whoops, I necroposted here. Disregard.

Re: rotateing radars

by medic22 » Mon Oct 06, 2014 10:13 am

Thank you for ideas the advice iis a start. In the right directiowill keep you updated

Re: rotateing radars

by marijn van gils » Mon Oct 06, 2014 8:46 am

I would look into model railroad stuff. They have an amazing amount of moving accessories to make their landscapes come alive, using electrical motors, and I'm sure you can find something with an axis which turns at the right speed.

If it doens't have a battery attached, you will have to connect this to a battery of the right voltage (or fit a resistor), and an on-off switch of some sort. These are all easy enough to obtain and connect. Deciding on the best location for the switch will be another matter!

Cheers,

Marijn

Re: rotateing radars

by GazzaS » Mon Oct 06, 2014 4:15 am

At the minimum you will need a small electric motor and a reduction gear. Small pulley turns a larger pulley with a belt or chain. The large pulley is at the base of the shaft attached to your radar. The shaft will have to be fixed so it doesn't wiggle or rattle. Bearings fixed to your model would be a wise investment.

Your first step should be your local R/C hobby store. They may be able to save you a lot of wasted time and effort.

Good luck!

rotateing radars

by medic22 » Fri Oct 03, 2014 9:58 pm

Iam asking for some help iam trying to make the sps48&49 on my carriers to rotate any help would be grateful








ed some hrlp I am trying to mske thr sps48&49on my carrirrs rotste. Iam








ssking for
someideas in figuring out this issue. .o

Top