Hear she is...all 1.5 metres of her!
I managed to find a dockyard drawing so had the hull bulkhead lines with rear and front views to work from and then only the starboard side elevation so a huge amount of research had to follow. The drawing I had was also "as proposed" so the ship "as launched" differed in some detail (particularly the fwd mast).
On "maiden voyage" I found that the scale rudders were not doing a very good job and I had to go about 30% overscale when I remade the rudders. She still has a pretty wide turning circle but now much better than she was.
Main motors are Mtroniks 600's running on a Hobbywing 860 twin screw ESP on 6v. 5 bladed Props are to scale taken from the drawing and homemade as are the prop tubes.
Her homemade jet drive was only tested several weeks later and it performed well. Think that the (nondescript) motor is also about a 550 running on it own Hobbywing 1060 ESP on 12v.
Radar arrays revolve. Hangar door is motorised as is the helicopter movement from the hangar. This is supposed to be sequentially wired so door up/helicopter out (it moves on a screw below the helideck with magnets on the screw carriage and under the chopper) /helicopter back into hangar/ hangar door closes....but this is proving to be beyond my limited electronics ability...any suggestions would be welcomed (I only have one channel left on my TX.)
Should there be any further interest in this model then I could post more pics.
Cheers
Tertius