by TommyL » Sat May 27, 2006 5:54 am
Andy thats not my workshop. I found that while surfing around do it yourself CNC conversions sites. Sorry if you thought that was mine.
My junk can be seen in the Any Thing But Ships section of this forum. Im the fool with the Induma knee mill build.
That little motor would be the cooest thing in a 1/4 or whatever scale RC drag boat!
The little motor was a 1" bore
A crank stroke of .90"
Eight cylanders.
Formula for figuring cubinc inch displacement:
Bore squared X Stroke X Number of Cylanders X .7845 wich is the quence area of the cylander heads.
Ex using this motor:
1" X 1" X .90" X .7845 X 8 = 5.6484 C.I.
Andy thats not my workshop. I found that while surfing around do it yourself CNC conversions sites. Sorry if you thought that was mine.
My junk can be seen in the Any Thing But Ships section of this forum. Im the fool with the Induma knee mill build.
That little motor would be the cooest thing in a 1/4 or whatever scale RC drag boat!
The little motor was a 1" bore
A crank stroke of .90"
Eight cylanders.
Formula for figuring cubinc inch displacement:
Bore squared X Stroke X Number of Cylanders X .7845 wich is the quence area of the cylander heads.
Ex using this motor:
1" X 1" X .90" X .7845 X 8 = 5.6484 C.I.