The Ship Model Forum

Hi Petros ,

instead of "Evergreen" stuff , way too expensive for the average modeller's wallet , I would use cardboard & paper , which can be impregnated with CA glue , it becomes very strong and after all , even if your glue tube is empty , it costs less than polystyrene strips or plates ...

another way , if you want to stay to plastic , you may buy ABS plates in some businesses , various thicknesses are available , it is sold by square meters ...

Brass won't be cheaper than "Evergreen" stuff , I think ...

keep us informed

Laurent

Hey guys

Im virtually ready to begin my very first semi-scratchbuild project, and I need help how to start it.

The project is to make an italian freighter in 1/350, in WW2 port. I prepared a hull from the revell's 1/380 Hawaiian Pilot for it, and a large number of photos. However, I decided against bying any plans, as I want this project to be on a very thin budget, and there were so many variations of freighter ships in italy in 1940-43 that a guess on photos can do the trick.. The superstructure will be complete scratchbuilt, and the deck partially.
So, my question - how you plan the scratchbuilt parts? Do you use pen and paper? Are you using some CAD software? Some 3d modeling software? How can you measure the hull curvature at the superstructure's base? After you have the plan on paper, do you just glue it on the plasticard or brass and then cut out? Where (in germany) do you get cheap plasticard, evergreen from the model store was quite expensive... Which thickness you take for the walls, decks and platforms?