by DeaD_Peter » Thu Jun 15, 2017 2:12 pm
Super work Jeff, it doesn't matter how long it takes, your way past the half way point now.
Looks awesome. Can't wait till you add the new addition and too bad the airfield was just a little further away, that would have been another
fantastic addition. Now I know you know more about water dios than me but I'll say it anyways, don't forget to add those few 1000 or so
little tiny tips of white to all those waves that are within 1/2 inch of shore and everything else before the next layer of water and then again
on top of the waves to give the water even more depth. That will bring the whole dio to life, but I'm sure you already knew this.
P.S. Is Pat still making 3-D printed chain ?? I need the same for my 1/200 Arizona, 3 - 13.5 LPI + 9 Chain Locks, and 5 chains for 3 - 1/200 Mikasa(s)
but I don't know what size the chains are for that ship, I'm thinking about somewhere between 16 LPI and 17.5 LPI Any help on that would be great.
And one last note. Thank you sooooo much for your WIP and research on the 1/200 Arizona. You and the few who helped you do all that work
will have saved me well over 40 to 50 hours of homework when I do eventually get around to doing my Arizona. Thanks again !
Edit: Don't worry about answering about Pat, I talked to him last week, ShapeWay's 3-D Printer can no-longer produce 13.5 LPI chain or the chain locks
so I am going to have to wait till they buy a brand new 3-D printer or someone else does, sounds like their printer is finally showing it's age, sucks
for me cause that is the last piece of the puzzle before I start my 1/200 Arizona.
Super work Jeff, it doesn't matter how long it takes, your way past the half way point now.
Looks awesome. Can't wait till you add the new addition and too bad the airfield was just a little further away, that would have been another
fantastic addition. Now I know you know more about water dios than me but I'll say it anyways, don't forget to add those few 1000 or so
little tiny tips of white to all those waves that are within 1/2 inch of shore and everything else before the next layer of water and then again
on top of the waves to give the water even more depth. That will bring the whole dio to life, but I'm sure you already knew this.
P.S. Is Pat still making 3-D printed chain ?? I need the same for my 1/200 Arizona, 3 - 13.5 LPI + 9 Chain Locks, and 5 chains for 3 - 1/200 Mikasa(s)
but I don't know what size the chains are for that ship, I'm thinking about somewhere between 16 LPI and 17.5 LPI Any help on that would be great.
And one last note. Thank you sooooo much for your WIP and research on the 1/200 Arizona. You and the few who helped you do all that work
will have saved me well over 40 to 50 hours of homework when I do eventually get around to doing my Arizona. Thanks again !
Edit: Don't worry about answering about Pat, I talked to him last week, ShapeWay's 3-D Printer can no-longer produce 13.5 LPI chain or the chain locks
so I am going to have to wait till they buy a brand new 3-D printer or someone else does, sounds like their printer is finally showing it's age, sucks
for me cause that is the last piece of the puzzle before I start my 1/200 Arizona.