by Guest » Tue Jun 23, 2009 5:04 pm
Re the question on the bridge: since I built the model, I will answer the question.
This version of the design had two retractable islands, one port and one starboard. On the model, you can see the starboard (right) side island in the raised position with the port side in the lowered position.
F7U's are carried for CAP; P2V's are strike aircraft; F2H Banshee's are the fighter cover for the bombers.
I found a lot of references for the United States, but I used an earlier design study as shown in Conways All the World's Fighting Ships as the pattern. As I was planning the project, I starting figuring all the things that needed to be fixed on the design and thought about doing a "active duty" model, but the more I tweaked, the more the design ended up looking like Forrestal, so I just switched back and built it like the drawing.
I'm going to add some pictures of my 1957 Forrestal to that discussion group.
Re the question on the bridge: since I built the model, I will answer the question.
This version of the design had two retractable islands, one port and one starboard. On the model, you can see the starboard (right) side island in the raised position with the port side in the lowered position.
F7U's are carried for CAP; P2V's are strike aircraft; F2H Banshee's are the fighter cover for the bombers.
I found a lot of references for the United States, but I used an earlier design study as shown in Conways All the World's Fighting Ships as the pattern. As I was planning the project, I starting figuring all the things that needed to be fixed on the design and thought about doing a "active duty" model, but the more I tweaked, the more the design ended up looking like Forrestal, so I just switched back and built it like the drawing.
I'm going to add some pictures of my 1957 Forrestal to that discussion group.