I asked Tommaso Balconi at ModelFunShipyard to do designs for the Essex Class SCB-125 ships. I sent him pics and plans for USS Bon Homme Richard CVA-31, USS Intrepid CVS-11, and USS Yorktown, CVS-10. I am happy to report that they came out quite nice and I am quite happy with the results. The texture is a little rough but pretty easy to sand out. The bow for the Yorktown is incorrect( he did the knuckle bow) but I am doing the Kearsarge CVS-33 so it is correct for Kearsarge and Hornet if you want to do one of those ships. If you communicate with him on doing the correct "rounded" bow for Yorktown and her other "Hydraulic Catapult" sisters then he would do that for you. The rounded Bow for Bonny Dick is very well done! Should be pretty easy for him to move that over to the Yorktown design. The masts are a bit thick so I will likely re-work them from scratch but they give you a good pattern to work from should you want to do that. I am also using PE for the Radars vice the 3D Printed Radars. If you want a 1/700 scale SCB-125 ship and can't find a Jim Shirley USS Oriskany (Good Luck with that!), this is it. They are not cheap though. I opted for the better, smoothest fine detail plastic option and that bumps up the cost a lot.
https://www.shapeways.com/shops/modelfun-shipyardBrowse through the 1/700 ships link and the parts to do all three are there. He has also done a 1/700 SCB-27C USS Hancock CVA-19 if you want one of those.
Good Luck,
Mark