Hi all,
Thanks a lot for your kind remarks. It is my pleasure to share this with colleagues.
The work of today was quite tedious, the exterior vent exhausts -- i think from the hangar, but i am not very sure.
The offering from Lee was a very odd looking grid :
I had to cut off all the holes after stripping both bulkheads off all the details, until I got this :
I had to place two supports inside, and then to cut all the pieces one but one, setting everyone in place before cutting the next. Quite monotunous and exasperating, but obviously this is a hobby -- nobody was compelling me to do anything...
It was then like this :
As I was fed up with strips I thought I could do something a bit more pleasant, so I started the aft hangar bulkhead too :
The process was the same, to strip the piece off all details, to open the holes and to complete it.
The articulated doors are made with Evergreen "V-Groove" # 2025 which most suitable for it.
The white lines in yogourt plastic are necessary for the painting.
And it is now like this, almost complete minus the two ladders and some minor details
Quedó finalmente así, a falta de las escalas y algunos detalles menores :
And that´s all for today.
I hope you like it, and best regards,
Willie.
How did you cut out those holes so precise? What tool or tools did you use. I tried to do this on a spare and it was a disaster.