The Ship Model Forum http://www.shipmodels.info/mws_forum/ |
|
1/700 Victorieuse http://www.shipmodels.info/mws_forum/viewtopic.php?f=59&t=166494 |
Page 2 of 2 |
Author: | Pieter [ Wed Jan 31, 2018 2:51 pm ] |
Post subject: | Re: 1/700 Victorieuse |
The lower connections of each level are in the kit, I just drilled them out and made them stronger. The upper ones are simply 1mm evergreen strip. |
Author: | Pieter [ Wed Feb 07, 2018 10:52 am ] |
Post subject: | Re: 1/700 Victorieuse |
Over the past week I have mainly been playing with water. I cut out some watercolor paper and glued it to the base. Attachment: Unlike some others here on this board I chose to not seal the watercolor paper with glue at first but I put basic (department store) blue acrylic paint on it in two layers. The paper would start deforming and forming blisters as a result and by selectively glueing some of the paper back to the base I could get the wave pattern I want to see here. Once everything was thoroughly dry (48hrs) I added a top layer of acrylic gel and screwed Victorieuse on its base. Attachment: Next step: boats and fittings. |
Author: | Pieter [ Tue Mar 13, 2018 4:29 pm ] |
Post subject: | Re: 1/700 Victorieuse |
Its been a busy month but not at the workbench. I did manage to get myself in trouble though. When I had place the masts and started measuring out the rigging I found out that the foremast ratlines, the anchors and the forward secondary guns would interfere with each other. After looking through my pictures I found that the guns were some 5mm too far forward and that the anchors would fit into a large cutout rather than be secured to the bulwarks. Lots of cutting and rebuilding gave me this. Attachment: While I was staring at pictures I also found that Victorieuse had a smaller bridge when she was just commissioned. Attachment: brug.JPG [ 39.26 KiB | Viewed 313 times ] And I decided to rebuild the main guns again to an open, not shielded, configuration. Attachment: And that is where I am now. The photo etch is now at the paint shop getting primed and made a picture with her half sister Bayard which will be in a late configuration with cut down masts if I ever finish her. Attachment:
|
Page 2 of 2 | All times are UTC - 6 hours [ DST ] |
Powered by phpBB® Forum Software © phpBB Group https://www.phpbb.com/ |