verticle ladder rungs

modelman62 · Post by **modelman62** » Tue May 10, 2005 4:23 am

I'm a bit miffed here. When doing verticle ladders, where do you cut off the two side supports at?

Like where im pointing in the first pic, where do you cut that off at? and how do you measure it to be sure the two at one end are the exact same as the two at the other end?
Or do you cut it off as in pic 2.

http://img.photobucket.com/albums/v44/i ... rrung1.jpg

http://img.photobucket.com/albums/v44/i ... errung.jpg

ARH · Post by **ARH** » Tue May 10, 2005 6:53 am

Have a look at calling all flower class, my bryony poto,s 5 , up the funnel , photo 10 on the side of the bandstand, hope this helps, ARH

Vlad · Post by **Vlad** » Tue May 10, 2005 10:33 am

I always cut as in the first picture then bend the two "legs" at 90 degrees so when I glue the ladder it sticks out from the side of the superstructure slightly.

kevinb120 · Post by **kevinb120** » Fri May 13, 2005 10:09 am

Vlad wrote:I always cut as in the first picture then bend the two "legs" at 90 degrees so when I glue the ladder it sticks out from the side of the superstructure slightly.

ditto

Sylvain Auger · Post by **Sylvain Auger** » Fri May 13, 2005 10:17 am

Vlad,

I will try this method of working with ladders. Thanks for the tip!

Cheers!