Had a tweezer mishap and unknowingly launched my nice little Pontos PE accom ladder into the nether. Just spent well over an hour on my hands and knees, then combed every possible horizontal surface and ledge in the room, patted myself down and checked every pocket and crease in my clothing (multiple times), reorganized/inventoried my work bench, checked every possible crevice and crack, even swept the floor (top of carpet and underneath), until the only place left un-searched was my almost full waste basket. Began uncrumpling each paint-stained paper towel and examining every scrap of masking tape, every Q-tip, and all other detritus until low and behold, there it was at the very bottom...happy days!
Note to self, get a trachcan with a lid.
Cheers,
Keith
Put a lid on your trashcan
Moderator: JIM BAUMANN
- Admhawk
- Posts: 958
- Joined: Sat Feb 03, 2007 1:00 pm
- Location: Bowmanville, ON, Canada
Re: Put a lid on your trashcan
I'd bet your shop has never been tidier!! 
Darren (Admiral Hawk)
In the not so tropical climate of the Great White North.
In the not so tropical climate of the Great White North.
- dafi
- Posts: 1005
- Joined: Mon Mar 12, 2012 11:13 am
- Location: Ludwigsburg/Germany
- Contact:
Re: Put a lid on your trashcan
Had the same experience - my can is covered since that day 
XXXDAn
XXXDAn
To Victory and beyond ...
viewtopic.php?f=59&t=99050&start=60
See also our german forum for the age of Sail and History:
http://www.segelschiffsmodellbau.com
viewtopic.php?f=59&t=99050&start=60
See also our german forum for the age of Sail and History:
http://www.segelschiffsmodellbau.com
-
PATMAT
- Posts: 442
- Joined: Fri Jan 21, 2005 8:24 pm
- Location: Temecula
- Contact:
Re: Put a lid on your trashcan
Should put a lid on it anyway for fire safety. Even a simple lid is better than nothing, if you don't want to pop for a fire proof can.
I was always nervous about all the paint and solvent and spray adhesive soaked paper I was throwing in my can... replaced it with an inexpensive galvanized steel "ash can".
I was always nervous about all the paint and solvent and spray adhesive soaked paper I was throwing in my can... replaced it with an inexpensive galvanized steel "ash can".
Pat Matthews
Get your boats wet!
Blog: [redacted]
Shapeways Shop: [redacted]
MWS Gallery: http://www.modelshipgallery.com/gallery ... index.html
Get your boats wet!
Blog: [redacted]
Shapeways Shop: [redacted]
MWS Gallery: http://www.modelshipgallery.com/gallery ... index.html