The Ship Model Forum

The Ship Modelers Source
It is currently Fri Apr 19, 2024 2:43 am

All times are UTC - 6 hours [ DST ]




Post new topic Reply to topic  [ 11 posts ] 
Author Message
 Post subject: RV Le Suroit
PostPosted: Mon Jun 11, 2018 4:52 pm 
Offline
User avatar

Joined: Tue Dec 29, 2009 1:38 pm
Posts: 44
Location: New Mexico, USA
Image
The French RV Le Suroit (“Sou’wester”). I build this model using an old Heller kit (1/200 scale) that I had been dragging around for 20+ years. The original kit was configured as she would have been prior to her extensive refit in 1999. I modeled her in her current configuration using photoetched parts and scratch built components.
Image
Le Suroit is operated by the French oceanographic insititute IFREMER. (The Institut français de recherche pour l'exploitation de la mer that translates to: French Research Institute for Exploitation of the Sea). The vessel was commissioned and built in 1975 by Ateliers et Chantiers de la Manche in Dieppe, on the northern coast of France. She was the second research vessel build in a series, the first being RV Le Noroit (“Nor’wester”) which has been withdrawn from active service.
Homeported in Brest on the western tip of France Le Suroit is 184.8 ft. (56.34 m) LOA, has a beam of 36 ft. (11 m), a draft of 13.5 ft. (4.10 m) and displaces 1,132 tons. She is equipped with A frame and gallows frames and numerous winches for deployment of various underwater survey equipment. The large gallows frame on the stern is used to deploy the small, highly maneuverable submersible Cyana. This DV was included with the kit but I added extensive detail to it.
Image
The real vessel is equipped with a range of devices. The computers run IFREMER's CARAIBES mapping software. The coring cable is 5.0 mi (8 km) long and is made of Kevlar. It has a safe working load (SWL) of 8 tons. The ship also has a 3.7 mi (6 km) steel winch, with an SWL of 2.1 tons. The average cruising speed, and the speed at which surveying is undertaken, is approximately 10 knots.
Image
In 1985, the ship was equipped with the new System Acoustique Remorquè (SAR) sonar device and then in early summer of that year she undertook a 10-day sonar mission in an attempt to find the wreckage of RMS Titanic. Aboard Le Suroit on this mission was Dr. Robert Ballard. Le Suroit was able to rule out large sections of a pre-determined 150-square-mile search area – between 26 July and 6 August, 80% of the area had been searched. It later transpired that on one of its first passes, Le Suroit had come within only 3,300 feet (1,000 m) of Titanic. The mission ended on 6 August, after which RV Knorr travelled from the Azores to concentrate on more specific areas using different strategies.
Image
The back story of Le Suroits search for the Titanic was only recently released to the public. Ballard met with the Navy in 1982 to request funding to develop the robotic submersible technology he needed to find Titanic. The Navy told Ballard they were interested in the technology—but for the purpose of investigating the wreckage of the U.S.S. Thresher and U.S.S. Scorpion. Since Ballard's technology would be able to reach the sunken subs and take pictures, the oceanographer agreed to help out. He then asked the Navy if he could search for the Titanic, which was located between the two wrecks. The Navy emphasized that the mission was to study the sunken warships. Once Ballard had completed his mission—if time was left— Ballard could do what he wanted, but never gave him explicit permission to search for the Titanic.
The Thresher and Scorpion had sunk in the North Atlantic Ocean at depths of between 10,000 and 15,000 feet (3,000 and 4,600 meters). The military wanted to know the fate of the nuclear reactors that powered the ships. This knowledge was to help determine the environmental safety of disposing of additional nuclear materials in the oceans.
The Navy also wanted to find out if there was any evidence to support the theory that the Scorpion had been sunk by the Soviets. (No evidence to support this theory was ever found). Ballard's data showed that the nuclear reactors were safe on the ocean bottom and were having no impact on the environment.
While searching for the sunken submarines, Ballard learned an invaluable lesson on the effects of ocean currents on sinking debris: The heaviest stuff sinks quickly. The result is a debris trail laid out according to the physics of the currents.
When Ballard had completed the Navy portion of the underwater search he had just 12 days to search for the Titanic, using the information accumulated to track down the ocean liner. He speculated that the ship had broken in half and left a debris trail as it sank. And that’s exactly what happened and it was the bottom debris field that, once located, lead Ballard and his team to the grave of the Titanic.
Image
Le Suroit has an unusual asymmetrical bridge. There is no open starboard bridge wing because the navigation bridge is built to span all the way to the starboard side of the ship. However on the port side the enclosed bridge portion of the superstructure stops short of running the full width of the ships beam and there is an open port bridge wing area.

_________________
Joe
An Old, Retired Coastie!


Report this post
Top
 Profile  
Reply with quote  
 Post subject: Re: RV Le Suroit
PostPosted: Mon Jun 11, 2018 8:47 pm 
Offline
User avatar

Joined: Wed Feb 09, 2005 5:45 pm
Posts: 1562
Location: Abu Dhabi
Superb job Joe !!

Very sharp and good looking ship ,must confess that I am not very fond on non warship vessels ,but You did a fantastic job on this one , thanks for sharing it ,a very enjoyable experience.

_________________
No Whine Policy
1.- Modify it
2.- Ignore it
3.- Don't build it


Report this post
Top
 Profile  
Reply with quote  
 Post subject: Re: RV Le Suroit
PostPosted: Tue Jun 12, 2018 11:55 am 
Miguel
Tks for the nice comments. Glad I was able to get you into a different modeling "zone" other than naval. I'm just the opposite from you in that I prefer non-military type hulls to build.


Report this post
Top
  
Reply with quote  
 Post subject: Re: RV Le Suroit
PostPosted: Tue Jun 12, 2018 12:54 pm 
Very good job! :thumbs_up_1:


Report this post
Top
  
Reply with quote  
 Post subject: Re: RV Le Suroit
PostPosted: Wed Jun 13, 2018 12:34 pm 
Offline

Joined: Tue Jun 14, 2005 6:23 am
Posts: 3698
Location: Bonn
Very nice model! :thumbs_up_1: And nice to see a model of a research ship!

And thank you also very much for the details about the real ship!

I would also like to built one of the IFREMER ships - but in 1/700. Your model is a nice reference!

_________________
Image


Report this post
Top
 Profile  
Reply with quote  
 Post subject: Re: RV Le Suroit
PostPosted: Fri Jun 15, 2018 8:10 am 
Offline

Joined: Sat Sep 17, 2005 9:19 am
Posts: 1483
Love that paint job!


Report this post
Top
 Profile  
Reply with quote  
 Post subject: Re: RV Le Suroit
PostPosted: Mon Jun 18, 2018 9:03 am 
Appreciate the kind words. This build did present some challenges especially with the paint scheme since I use rattle cans. The masking was "fun" to say the least.


Report this post
Top
  
Reply with quote  
 Post subject: Re: RV Le Suroit
PostPosted: Fri Jul 06, 2018 2:27 am 
Offline
User avatar

Joined: Mon Mar 23, 2015 1:46 pm
Posts: 89
Very well done! What set of photoetch did you use? The 1/200 from L' arsenal for ladders? Railings?


Report this post
Top
 Profile  
Reply with quote  
 Post subject: Re: RV Le Suroit
PostPosted: Mon Aug 20, 2018 12:46 am 
Offline

Joined: Wed Jan 26, 2005 10:12 pm
Posts: 1321
Location: Up The Street From Sam Wilson's House
Nice!!!

_________________
Thomas E. Johnson

http://www.youtube.com/user/ThomasEJohnson


Report this post
Top
 Profile  
Reply with quote  
 Post subject: Re: RV Le Suroit
PostPosted: Mon Aug 20, 2018 8:28 am 
Offline
User avatar

Joined: Sun May 20, 2012 6:01 am
Posts: 409
Location: Ontario Canada
Well done. :thumbs_up_1:

Scott

_________________
K494 HMCS Arnprior
Royal Canadian Navy


Report this post
Top
 Profile  
Reply with quote  
 Post subject: Re: RV Le Suroit
PostPosted: Mon May 10, 2021 4:04 am 
Offline
User avatar

Joined: Fri Dec 12, 2008 12:44 pm
Posts: 1775
Location: Herk-de-Stad, Belgium
My good friend Jan de Boer (master of a fishery cutter himself) just sent me pictures of his rendering of Le Suroit (better: Le Suroît...). Not even out of the workhop yet! I urged him to send some pictures with a neutral background as well.

Besides Joe's very well detailed model, Jan's stands out for me for its realistic weathering and fine colors.
Attachment:
processed (1).jpeg
processed (1).jpeg [ 298.43 KiB | Viewed 940 times ]
Attachment:
processed (2).jpeg
processed (2).jpeg [ 303.81 KiB | Viewed 940 times ]
Attachment:
processed.jpeg
processed.jpeg [ 318.97 KiB | Viewed 940 times ]

_________________
"I've heard there's a wicked war a-blazing, and the taste of war I know so very well
Even now I see the foreign flag a-raising, their guns on fire as we sail into hell"
Roger Whittaker +9/13/2023


Report this post
Top
 Profile  
Reply with quote  
Display posts from previous:  Sort by  
Post new topic Reply to topic  [ 11 posts ] 

All times are UTC - 6 hours [ DST ]


Who is online

Users browsing this forum: No registered users and 39 guests


You can post new topics in this forum
You can reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Jump to:  
Powered by phpBB® Forum Software © phpBB Group