The Ship Model Forum

Okay, it looks like we may finally be about there. I've uploaded the midships tub and clipping room assembly to Shapeways. Here's the question: what did I miss? Anythign obvious? Any ideas?

https://www.shapeways.com/product/JKHFM ... b1f1b84254

There is no sheer nor camber on the part, as requested by the gentleman who requested it. I have included a pair of 2.5 millimter tall plugs in the assembly to raise the clipping room or to compensate for the modeler sanding and shaping too much.

Thanks!

Why is there a spare barrel locker on the outside (hull side) of the 40-mm bulwark for one waist "tub"? In this view it doesn't appear to be a separate piece. Could be that it is, but can't be seen from this angle.

They are separate pieces. Its just the perspective that makes them seem as one.

I suspected as such, but if it was accidentally placed as part of the bulwark, it would make for hard time removing it.

Are there any possible plans for the 40mm director tubs for the top of the enclosed bridge Fletchers? And/or an open searchlight platform for the forward stack?

Thanks