Revell 1/72 Type VIIC/41 `U995`
Posted: Sun Aug 21, 2011 1:38 pm
Hello,
my name is Karel Ton from The Netherlands, and i just registered here on the forum.
Recently, i finished my u-boot project; a Revell kit with almost every accessory available for it.
-Nautilus wooden deck
-Eduard VII/C PE kit
-White Ensign models type VII flood, drain and vent holes PE kit
-Griffon FLAK-guns high detail kit
-Modelbrass type VII PE kit
-Archer transfers type VII rivet decal set
I opened al the floodholes, added ribs inside the hull above the saddletanks, remade the railings from 0.5mm brass wire, scratchbuild the whole exhaust system wich lies beneath the deck, `oil canned` the hull, replaced about 800 rivets wich were sanded away, corrected the `bull nose` and corrected all the faults in this kit (wich are many....)
Thanks for watching,
Karel
my name is Karel Ton from The Netherlands, and i just registered here on the forum.
Recently, i finished my u-boot project; a Revell kit with almost every accessory available for it.
-Nautilus wooden deck
-Eduard VII/C PE kit
-White Ensign models type VII flood, drain and vent holes PE kit
-Griffon FLAK-guns high detail kit
-Modelbrass type VII PE kit
-Archer transfers type VII rivet decal set
I opened al the floodholes, added ribs inside the hull above the saddletanks, remade the railings from 0.5mm brass wire, scratchbuild the whole exhaust system wich lies beneath the deck, `oil canned` the hull, replaced about 800 rivets wich were sanded away, corrected the `bull nose` and corrected all the faults in this kit (wich are many....)
Thanks for watching,
Karel
