The Ship Model Forum

by **PetrOs** » Mon Nov 27, 2006 2:51 pm

I usually use toothpicks for CA application. However, that applicator looks quite interesting, might consider building it.

by **j leyland** » Mon Nov 27, 2006 1:43 pm

I have made a set of these and use them occasionally, but my favorite is the pointed ends of sprue left over from stretching. They can be made as fine and as long as necessary to reach difficult places.

by **Tom Naylor** » Mon Nov 27, 2006 12:13 am

Thanks Jim.

Now I have an excuse to drink that $5.00 a bottle of wine/vinager [housewarming present] collecting dust above the fridge. You know, for shipbuilding purposes. I'll bet it's especially handy for the thinner varieties of CA glues, which seem to take on a life of their own whenever I use them.

Best Regards,

Tom Naylor

by **Commodore Rob** » Tue Oct 31, 2006 4:49 pm

I normally use a straightened paper clip

being a gaget freak i may just create a cork and needle applicator:)

by **les** » Wed Oct 25, 2006 8:45 am

Thanks Jim! I made one yesterday and it works like a champ.

by **Filipe Ramires** » Tue Oct 24, 2006 11:09 am

Interesting tool indeed. I use normally a paper clip (depending of the size of the part and the ammount of glue to be used) or streched sprue or even rod brass. Until now works out fine and when glue keeps forming on the tool either I cut it or remove it with a sharpe blade.

by **Rob** » Tue Oct 24, 2006 10:53 am

mike mccabe wrote:I just use a bit of wire, when it goes all gunky I trim the end off.

Mike

I do the same.

Rob

by **David Griffith** » Tue Oct 24, 2006 8:59 am

I can vouch for the usefulness of this device. I've been using it to apply CA for years, and it works a treat.

Regards,

David Griffith

by **JIM BAUMANN** » Mon Oct 23, 2006 6:29 pm

the purpose of the forky bit is to allow the applicator to retain a single small droplet(pending size of needle!!!) to be held via capillary action

To clean it simply pass the fork thru a candle/lighter flame...

It does work--but then I personally apply my CA using the edeg of a stanley knife blade!!-still--I can see applications for the one I made tihs evening!!

JIM B

by **mike mccabe** » Mon Oct 23, 2006 5:07 pm

I just use a bit of wire, when it goes all gunky I trim the end off.

Mike

by **diezmon** » Mon Oct 23, 2006 1:42 pm

Or, google-ized

http://translate.google.com/translate?s ... %3fid%3d79

What's the purpose of the little "fork" anyway? I've seen other designs like that before.. and how does one keep it unclogged?

Tim

by **JIM BAUMANN** » Mon Oct 23, 2006 1:19 pm

Hi guys

here is a step by step guide on how to make a Superglue applicator--text is in german but the pictures are self explanatory!

http://www.modellversium.de/tipps/artikel.php?id=79

I am off to go and raid the sewing box...!

Jim Baumann

The Ship Model Forum

How to make a CA Glue applicator...

Post a reply

Expand view Topic review: How to make a CA Glue applicator...

applicator

How to make a CA Glue applicator...