CA drops on a file

Post a reply

Confirmation code
Enter the code exactly as it appears. All letters are case insensitive.
BBCode is ON
[img] is ON
[url] is ON
Smilies are OFF
Topic review
   

Expand view Topic review: CA drops on a file

by ARH » Sun Dec 24, 2006 11:37 am

Anonymous wrote:
Try the burning it off with a torch lighter.

Holding a lit match under the spot would do it and not get too hot.


WHAT YOU HAVE TO REMEMBER IF YOU DO THIS, IS TO DO IT OUTSIDE AND WEAR A MASK, IT GIVES OFF CYANIDE FUMES, :lol_3: :lol_3: :thumbs_up_1:

by HMAS » Sun Dec 24, 2006 8:22 am

Tom Naylor wrote:Try the burning it off with a torch lighter. .
Alternatively put Acetone on it ( nail polish remover) I use it to seperate human parts in the surgery.
use it all the time
Tony

by Guest » Thu Dec 21, 2006 12:18 pm

Try the burning it off with a torch lighter.

Holding a lit match under the spot would do it and not get too hot.

by Tom Naylor » Tue Nov 28, 2006 1:13 am

Try the burning it off with a torch lighter. Be careful not to remove the temper by getting it too hot and glowing red - you could also use aligator clips or pliers as heatsinks to draw some of the heat away while it's under the flame.

by Foeth » Mon Nov 27, 2006 3:42 pm

Just use a knife with a sharp point and scrape it off, line by line.

by Sylvain Auger » Mon Nov 27, 2006 3:24 pm

Hello!

I heard Easy-Off will remove CA glue. Some people uses it to remove paint and PE parts from models to rebuild them. If it works on plastic I don't see why it wouldn't work on a file.

Hope this helps :thumbs_up_1:

CA drops on a file

by PetrOs » Mon Nov 27, 2006 2:52 pm

Hello,

Does anyone know a method how to remove a drop of CA glue from a file?

Happened to my favourite file yesterday ;o(

Top