Cutting the thin tubing

Post a reply

Confirmation code
Enter the code exactly as it appears. All letters are case insensitive.
BBCode is ON
[img] is ON
[url] is ON
Smilies are OFF
Topic review
   

Expand view Topic review: Cutting the thin tubing

by Foeth » Mon Dec 11, 2006 4:46 am

That's how tubing is bent in real life!

Perhaps using a lathe works as well. I have one, but I took it apart last christmas....

by Jason M. » Sun Dec 10, 2006 6:38 pm

MichelB wrote:Insert a smaller, solid rod in the tube that fits tightly. Then you can cut without the barrel deforming. Not sure if this works for hypodermic needles, though...
Thats friggin brilliant!

by MichelB » Sun Dec 10, 2006 5:00 pm

Insert a smaller, solid rod in the tube that fits tightly. Then you can cut without the barrel deforming. Not sure if this works for hypodermic needles, though...

by les » Sun Dec 10, 2006 10:37 am

Tubing cutter may work. They make a small one.

by Jason M. » Sat Dec 09, 2006 7:30 pm

I was just having this same problem today, why didn't I think of that? I even went as far as trying to use a hack saw! :lol_3:

by PetrOs » Sat Dec 09, 2006 11:35 am

Hey thanks for an ultra-fast answer!
It really works, just tried it with my proxxon.

Cutting Small Thin Tubing

by Richard Durham » Sat Dec 09, 2006 11:30 am

I use a Dremel tool with a cutting disk and then sand with a sanding stick to clean up the ends. Most Dremels come with cutting disks included. Rich

Cutting the thin tubing

by PetrOs » Sat Dec 09, 2006 11:21 am

Hello,

I decided to replace some of the barrels of 5 inch AA guns with the pieces of thin steel tubing (coming from the medical 0.5 mm thick injection needles, which are just right in 1/350 scale). However, I have a question - how to cut the tubes right, so the opening is not deformed?

Any tips?

Regards,
Petr

Top