camber

Post a reply

Confirmation code
Enter the code exactly as it appears. All letters are case insensitive.
Smilies
:smallsmile: :wave_1: :big_grin: :thumbs_up_1: :heh: :cool_1: :cool_2: :woo_hoo:
View more smilies
BBCode is ON
[img] is ON
[url] is ON
Smilies are ON
Topic review
   

Expand view Topic review: camber

by Laurent » Sat Dec 30, 2006 4:06 pm

Hi Tarsier ,

the camber ( the curve ) itself remains the same for the whole length of the ship , to get an even curved deck.

Of course , at the bow and at the stern , the deck centre height will be less than at midship .

Regards ,

Laurent

by ARH » Sat Dec 30, 2006 1:49 pm

If your ship is 18ft wide the camber would be just under 3 inches, 9ft from each side from the cente line, the camber would reduce the shorter the distance to the edge from the centre line. :wave_1: :wave_1: :thumbs_up_1:

by tarsier » Sat Dec 30, 2006 1:40 pm

Is that 6 inches for every 20 feet from port to starboard? The boat I am working on is 72 feet long probably about 18 feet wide or so I would guess - about 11 inches *20 = 220 /12 = 18

so would I make it a little less than 6 inch camber? Is the camber the same throughout the length of the boat or less if the width goes down to say 12 feet towards the bow?

thanks ARH!

Tarsier

by ARH » Sat Dec 30, 2006 1:18 pm

On bigger ships its 6 inches in 20 ft.

sorry

by tarsier » Sat Dec 30, 2006 1:14 pm

this was supposed to be appended to my build, not a separate topic.

sorry

camber

by tarsier » Sat Dec 30, 2006 1:13 pm

Does anyone have any suggestions on how much camber I should be using? I figure 2 to 3 millimeters which at 1/20 scale would be 40 to 60 millimeters or 1 1/2 to 3 inches. Does this sound about right? too little?

thanks in advance.

Tarsier.

I haven't posted any pictures in a while. I am hoping to get the deck in, then attach the rub rails, I should be in good shape to post some pictures then.

Top