Bending the plastic parts

Post a reply

Confirmation code
Enter the code exactly as it appears. All letters are case insensitive.
BBCode is ON
[img] is ON
[url] is ON
Smilies are OFF
Topic review
   

Expand view Topic review: Bending the plastic parts

by les » Wed Jul 18, 2007 8:31 am

You can also use bendable plastic. I think Mid West stocks it.

by Rob » Wed Jul 18, 2007 7:10 am

Boil the water. I tend to tape the part to a curved piece of steel (such as a X-acto handle)or wood, plunge it in boiling water then run under a cold tap. To state the obvious, be careful about scalding yourself. I tend to drop the plastic in the water then fish it out with a pair of kitchen tongs.

Works rather nicely.

Cheers,

Rob

by PetrOs » Wed Jul 18, 2007 4:52 am

Okay, sounds good
How hot should it be?

by Rob » Wed Jul 18, 2007 3:12 am

Hot water is the best way to go,

Cheers,

Rob

by Sean Hert » Tue Jul 17, 2007 1:32 pm

I find it is much easier to control the heat with using hot water. Direct heat is too easy to let get away from you.

Bending the plastic parts

by PetrOs » Tue Jul 17, 2007 1:01 pm

Hello,

what is your method for bending or deforming the plastic parts? I need to simulate the battle damage, so it is necessary to bend a few parts.

Would you do it over a candle? In hot water? Over a soldering iron?

Top