How to do railings without photo etch?

Post a reply

Confirmation code
Enter the code exactly as it appears. All letters are case insensitive.
BBCode is ON
[img] is ON
[url] is ON
Smilies are OFF
Topic review
   

Expand view Topic review: How to do railings without photo etch?

by Kjetil L » Mon May 30, 2005 6:10 pm

Can be done by making a wooden frame or box, putting nails in the sides, make grooves in the edges the spacing of the stanchions one one side and the rails on the other side. The rail side of the box slightly higher than the stanchion side. Then string the whole thing with hairline copper wire like a guitar. Then pour thin superglue over the whole thing. When dry cut out some very thin and wery fragile rails.

by mike mccabe » Mon May 30, 2005 3:24 pm

Rob
I have some US style railings left over as I don't make many US kits and I have moved to ultra-fine anyway. Send me your address by pm and I will mail them to you, should be enough for one cruiser at least. May have a few other bits too.

Mike

!/700 scale Indianapolis

by Stratboy » Mon May 30, 2005 3:12 pm

I have the 1/700 Tamiya Indianapolis, I had thought of using a hard wire for uprights and thin copper wire for the rails themselves,
Rob

by mike mccabe » Mon May 30, 2005 1:44 pm

What scale are you working on and which ship?

Mike

by les » Mon May 30, 2005 1:18 pm

I do mainly 1/72nd scale and use plastic rod. I assemble it one piece at a time. I set the uprights first and then put in the cross pieces. I use Tamiya glue and when that's set I put Ambroid Liquid Glue on the joint. Hope this helps. :big_grin:

How to do railings without photo etch?

by Stratboy » Mon May 30, 2005 10:36 am

HI folks a newbie here so sorry if this has been asked a million times. How were railings etc. done in the days before photo-etch? I am on a tight budget but I'm great with scratchbuilding, so any hints?
Stratboy

Top