Hidding the bow seam on Enterprise

Post a reply

Confirmation code
Enter the code exactly as it appears. All letters are case insensitive.
BBCode is ON
[img] is ON
[url] is ON
Smilies are OFF
Topic review
   

Expand view Topic review: Hidding the bow seam on Enterprise

by Chas » Tue Apr 04, 2006 3:34 pm

Book is on its way - thanks Abram! :thumbs_up_1:

by ArizonaBB39 » Tue Apr 04, 2006 10:44 am

Basics of Ship Modeling: The Illustrated Guide By: Mike Ashey

There you go

by Guest » Tue Apr 04, 2006 10:04 am

do you have a link or know where to get this book from?

Thanks

by les » Tue Apr 04, 2006 9:36 am

I suggest you pick up a copy of Mike Ashley's book "The Basics of Ship Modeling." It should help you a lot. :wave_1:

by Chas » Tue Apr 04, 2006 6:44 am

I found some stuff called "green putty" online that's made specifically for models. Should I grind the seam prior to filling?

Chas

by ArizonaBB39 » Mon Apr 03, 2006 11:01 pm

I use Bondo auto body filler from an orange tube found at most auto supply stores or the auto section of Walmart, etc. It's a red putty and sands well, it just gets all over the place when you sand it, so be careful.

by Chas » Sat Apr 01, 2006 8:32 am

Yes this does have the seperate bow piece. I know the motorized kit I put together 40 years ago was 1 piece. Any recommendations on type of filler to use?

Thanks,
Chas

by Steve Hurrell » Sat Apr 01, 2006 4:51 am

Hi Chas,

Is it the Tamiya kit with the seperate bow piece that gets screwed into place?

If so, the upper parts of the join including the screws are covered by the forward sponsons, the rest of the joint will need to have a filler of some kind run down it and sanded smooth when dry.

Hope this helps a bit,

Stay safe

Hidding the bow seam on Enterprise

by Chas » Fri Mar 31, 2006 2:13 pm

My 1:350 1984 CVN 65 Enterprise arrived today! What I'm curious about is installing the bow. What is the best way to hide the obvious seams that I will have once I join the bow to the hull?

Thanks,
Chas

Top