Rhino 3.0 for Dummies?
Moderator: ArizonaBB39
-
Devin
- Posts: 2497
- Joined: Mon Jan 10, 2005 10:46 am
- Location: Hoboken, NJ
- Contact:
Rhino 3.0 for Dummies?
After checking out printapart.com at the NATS, I'm really itching to do some stuff in Rhino. Maybe design an ironclad or two that the manufacturers haven't tackled yet. Is there a good beginners book for Rhino? I'd need something to start from ground zero; I've used AutoCad in the past, but that was over 10 years ago. I'm pretty handy with Photoshop, which I've been told can help in Rhino, but I need something that starts me out at the very basics.
We like our history sanitized and theme-parked and self-congratulatory, not bloody and angry and unflattering. - Jonathan Yardley
-
Will J
- Posts: 57
- Joined: Sun May 04, 2008 7:00 am
Re: Rhino 3.0 for Dummies?
Have you looked at the McNeel site? There are some tutorials there. However the best place is this site. I'm on their forums too, its a great place for beginners and old hands alike.
-
Devin
- Posts: 2497
- Joined: Mon Jan 10, 2005 10:46 am
- Location: Hoboken, NJ
- Contact:
Re: Rhino 3.0 for Dummies?
Nice site, I'll give it a look. Thanks.
We like our history sanitized and theme-parked and self-congratulatory, not bloody and angry and unflattering. - Jonathan Yardley