Solid Hull 1/350 USS TEXAS

Post here for tips on modeling.

Moderator: JIM BAUMANN

Post Reply
Joe Brown
Posts: 3
Joined: Sat Jun 18, 2005 6:21 pm

Solid Hull 1/350 USS TEXAS

Post by Joe Brown »

Any suggestions on how to take the bow out of a 1/350 solid resin hull?I am afraid it would melt any details before getting soft.
Those who are ready to sacrifice freedom for security ultimately will lose both --Abraham Lincoln
Top
User avatar
Kym Knight
Posts: 591
Joined: Thu Jan 13, 2005 5:21 pm
Location: Sarina, Nth Queensland

Post by Kym Knight »

Try very hot water, then placed on flat surface and hold till cooled.
Image


I was depressed last night, so I rang lifeline. Got a call centre in
Afghanistan and told them I was suicidal.

They got all excited and asked if I could drive a truck.
Top
Joe Brown
Posts: 3
Joined: Sat Jun 18, 2005 6:21 pm

Post by Joe Brown »

Thanks Kym but keep in mind this is a SOLID resin hull.It is aprox 3 1/2 inches thick and weight is about 4 pounds.I will give that a try and see if it works...Joe............................... Democracy is two wolves and a lamb voting on what to have for lunch...Liberty is a well armed lamb contesting the vote -Benjamin Franklin
Those who are ready to sacrifice freedom for security ultimately will lose both --Abraham Lincoln
Top
Post Reply

Return to “Tips and Tricks”