Solder for a cage mast?
Moderator: JIM BAUMANN
-
Jon C Ryckert
- Posts: 582
- Joined: Sat Jun 06, 2009 12:40 pm
Solder for a cage mast?
My experience with solder is like most people, by hand with an iron. If one was to make a cage mast for a model out of brass rod, what would be the preffered method. If there is one. Thanks for any replies.
-
EJFoeth
- Posts: 2911
- Joined: Wed Jan 21, 2009 1:51 pm
Re: Solder for a cage mast?
Hand solder should just work fine. If you have good solder and good flux, then you'd be able to solder the rod (or wire even). I put my experience here.