Hi Guys
Not sure if this is the correct forum to ask for help but I am getting desperate trying to form some PE on the Catapult/Kingfisher kit for my 1:200 Arizona. The Riich kit looks great and has a lot more detail than that of the Trumpy catapult on the stern. The big issue I have is the brass is far to soft and I cant even handle it without incurring damage - I had the same with the Trumpy PE but the White Ensign materials are fabulous to work with. The question is how can I easily increase the temper in the brass to make it workable and handleable?
Norman
Urgent advice needed on bending PE without damaging it?
Moderator: JIM BAUMANN
-
normanh
- Posts: 16
- Joined: Tue Feb 07, 2012 5:17 pm
- Location: Essex UK
Urgent advice needed on bending PE without damaging it?
Regards
NormanH
NormanH
-
kawubke
- Posts: 38
- Joined: Thu Dec 05, 2013 4:59 am