Drilling Scuttle Holes

Post a reply

Confirmation code
Enter the code exactly as it appears. All letters are case insensitive.
BBCode is ON
[img] is ON
[url] is ON
Smilies are OFF
Topic review
   

Expand view Topic review: Drilling Scuttle Holes

Working smarter, not harder

by Tim » Sat Mar 18, 2006 2:53 pm

Hi guys,
I got a friend from my model club to machine a knife handle down so that it will fit in the chuck of a cordelss screwdriver. Better control that 5000 rpm, and we'll see how difficult it is at @600 rom to do all the scuttles on a 1/600 Repulse.

Tim

by Tom Naylor » Thu Mar 16, 2006 3:05 am

An inexpensive set of reamers may help too. I use welding tip cleaners, which come in a variety of tiny wire sizes. Great for cleaning up a drilling operation.

by Devin » Fri Feb 17, 2006 10:47 am

I usually check Micro-Mark for such tools.

I think this drill set might be what you need. Add a pin vise and you're ready to go.

-Devin

by Victorious » Fri Feb 17, 2006 6:28 am

All micro drills are measured in thousands of an inch. You will just have to search harder. You need a hobby shop that supplies micro tools.
They are expensive if you compare them to ordinary drills and they are very delicate.

by Victorious » Thu Feb 16, 2006 6:21 pm

The best way is to drill a pilot hole, just large enough to get a small round needle file in there, then just open the hole out with the file, intil you get a nice tight fit for the scuttle. Depending on what scale you are talking about. If it's one of these 1/700 models, then forget the file method. Just use a fine micro drill

Drilling Scuttle Holes

by monkey » Thu Feb 16, 2006 5:52 pm

After much research (without actually buying any books :smallsmile: ), I decided to build the kako as furutaka since all the components have to be scratch built.

The hull has terrible molded scuttles and I plan on filling them with putty. Can anyone tell me which way is the best for drilling new ones? Thanks for all your help thus far. :thumbs_up_1:

Top