This may seem like a simplistic question but it is a problem that has been vexing me for years. Whenever I cut a length of plastic rod I have a terrible time getting a straight 90 degree cut. I have tried the "Chopper" and that is graet for angled cuts but not 90 degree. Other than putting it in a pin vice and cutting straight across the collett - which is very time consuming - does anyone have a trick that I ahve not thought of? I thank you in advance for any tips.
Mike Coleman
Cutting plastic rod
Moderator: JIM BAUMANN
-
Ron Smith
- Posts: 203
- Joined: Mon Jan 10, 2005 12:49 pm
- Location: Maryland
Re: Cutting plastic rod
Assuming it's truly round or close to it simply rolling it under a single edged razor will score it enough to snap it off. If you roll it straight the score should be a perfect 90 degrees.Mike Coleman wrote:This may seem like a simplistic question but it is a problem that has been vexing me for years. Whenever I cut a length of plastic rod I have a terrible time getting a straight 90 degree cut. I have tried the "Chopper" and that is graet for angled cuts but not 90 degree. Other than putting it in a pin vice and cutting straight across the collett - which is very time consuming - does anyone have a trick that I ahve not thought of? I thank you in advance for any tips.
Mike Coleman
How do I get the pen to write here? Now my screen's all smeared with ink.........